12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
NOTE:
1. The workpiece should always be 2-3 inches longer than the finished length
as the ends tend to be uneven.
2. The table should be lubricated with wax, frequently to ensure smooth
operation.
RESET BUTTON
The planer is fitted with an thermal overload protector. If the motor stops
running or fails to start.
1. Close the safety switch cover and
allow the motor to cool for five
minutes.
2. Press the reset button.
3. Raise the cover of the ON/OFF
switch and press the green ON
button, marked ‘I’.
MAINTENANCE
Always disconnect the machine from the mains supply before cleaning or
performing maintenance tasks.
This product is designed to operate with minimum of maintenance, however,
as with all power tools, cleanliness is essential in ensuring work is carried out to
a satisfactory standard. Always keep the table free of shavings/dust etc., and
clean the machine thoroughly after use. Use a low pressure air supply to blow
dust from air vents and other parts wherever possible.
Apply a thin film of wax to the table periodically. This will help keep the table
clean and allow the workpiece to slide more easily.
Do not use solvents to clean the machine as this could damage plastic
components.
CUTTING BLADE REMOVAL
Cutter blades will require sharpening or replacing. Care should be taken at all
times when handling them, they are very sharp, even when appearing to be
dull.
Blades must always be fitted as a pair and must be of the same type. Only fit
blades recommended by the Clarke International.
Summary of Contents for 6462130
Page 20: ......
