Clarke 195TEC, Operating & Maintenance Instructions

Page: 17 / 32

NOTE: These machines are designed to accept either the Clarke 5kg or 15kg wire
spools of mild steel, stainless steel or aluminium according to the type of metal you
wish to weld.Wire spools must be purchased separately. See your Clarke dealer for
full details.
B. Loading the Wire
Mig 230TEC
Plug the torch hose into
the socket on the front of
the welder and secure
by hand screwing in the
threaded connection.
1. Pressure plate
2. Mounting Shaft
3. Wire Spool
4. Collar
5. Flat Washer
6. Spring
1. IMPORTANT: Ensure that the gas and
electrical supplies are disconnected.
2. To fit the wire spool, firstly open the side
compartment by pulling the recessed
catch backwards.
3. Turn the plastic knob with cam (7) to the
position shown in Fig. 4, i.e. with the flat
uppermost, so that the latch is unlocked,
and pull off the collar (6).
4. Slide the spool on to the shaft, ensuring that
the Peg ‘A’ locates snugly in locating hole
‘B’, ensuring the direction of feed of the wire
is in the direction of the arrow.
Replace the collar - 4, (5kg
spool ONLY), and turn the
Plastic knob with cam (7)
through 180 degrees, to the
position shown in Fig.6 thereby
locking the spool on the shaft.
Fig.4
Fig.5
Fig.3
18