Clarke 195TEC, Operating & Maintenance Instructions

Page: 11 / 32

12
PREPARATION OF THE WORKING AREA
The working area must be sufficiently spacious, not humid, and well-ventilated as to
avoid any fumes which develop from the welding process and from incidental
material adhering to the pieces to be welded (oils, paints, tars...) which may cause
annoyance to the operator.
Avoid welding by contact with humid parts nearby combustible liquids. Least of
all, do not weld upon tanks which may contain flammable residuals.
ADDITIONAL SAFETY PRECAUTIONS for MIG WELDING
•
ALWAYS ensure that there is full free air circulating around the outer casing of
the machine, and that the louvres are unobstructed.
•
Welding arc can seriously damage your eyes. Both operator and spectators
must
ALWAYS use a proper welding face shield or helmet, with suitable filter
lenses. Proper gloves and working clothes should be worn at all times.
•
ALWAYS check that the pressure regulator and gauges (where fitted), are
working correctly. DO NOT lubricate the regulator.
•
ALWAYS use the correct regulator. Regulators are designed to be used with
a specific gases.
•
ALWAYS inspect the hose before use to ensure it is in good condition.
•
ALWAYS keep the free length of gas hose outside the work area.
•
ALWAYS remove all flammable materials from the welding area.
•
ALWAYS Keep fire extinguisher handy....’ Dry Powder, C0
2
or BCF, NOT Water
•
NEVER remove any of the panels unless the machine is disconnected from
the supply, AND never use the machine with any of the panels removed.
•
NEVER attempt any electrical or mechanical repair unless your are a qualified
technician. If you have a problem with the machine contact your local
CLARKE dealer.