49
VZ509A
English
Owner
’s ma
nua
l
❏
Setting the TEL Speaker
You can select the speaker which the telephone
calls are output.
• The factory default setting is “
Right
”.
❏
Performing the System Check
You can perform the system check by the
following operation.
❏
Resetting the navigation
system
You can reset the connected navigation system
from this unit.
Note:
•
This setting will be available when the Clarion
NAVI (Clarion Navi NP509A) is connected.
❏
Setting the anti-theft function
(CATS)
“CATS” is the acronym of “Clarion Anti-Theft
System”. When you set a PIN code (called as
“Personal Code”), a theft is prevented by
disabling the operation of the unit at the theft.
In addition, set the Blink LED function to improve
the effect of the CATS function (see page 48).
Setting your Personal Code
Note:
•
Write down your Personal Code in case you forget
it.
Erasing the Personal Code
3-1. Touch the [
System
] key to display the
System tab screen.
3-2. Touch the [
}
] key to display the next
screen.
3-3. Touch the [
Left
] or [
Right
] key of the TEL
Speaker item to select the speaker.
Left:
The telephone calls are output from the front
left speaker.
Right:
The telephone calls are output from the front
right speaker.
3-1. Touch the [
System
] key to display the
System tab screen.
3-2. Touch the [
}
] key to display the next
screen.
3-3. Touch the [
]
] key of the System Check item.
The System Check screen is displayed.
3-4. Touch the [
Start system check
] key to
perform the system check manually.
The system will be restarted after
performing the system check.
3-1. Touch the [
System
] key to display the
System tab screen.
3-2. Touch the [
}
] key to display the next
screen.
3-3. Touch the [
]
] key of the System Check item.
3-4. Touch the [
Reset NAVI module.
] key to
reset the navigation system.
3-1. Touch the [
System
] key to display the
System tab screen.
3-2. Touch the [
}
] key to display the next
screen.
3-3. Touch and hold the blank area just below
the [
]
] key of the System Check item for
more than 2 seconds.
The Personal Code screen appears.
• When a Personal Code is already set, the
Erase Code screen will appear. Retry this
operation after erasing the old Personal
Code.
3-4. Enter your desired 4-digit Personal Code by
touching the [
0
] to [
9
] keys, then touch the
[
ENT
] key.
• Touch the [
BS
] key when you make a
mistake in entering.
3-5. Enter the same Personal Code again for
confirmation, then touch and hold the [
ENT
]
key for more than 2 seconds.
The entered Personal Code will be set, and
it will return to the previous screen.
3-1. Touch the [
System
] key to display the
System tab screen.
3-2. Touch the [
}
] key to display the next
screen.
3-3. Touch and hold the blank area below the [
]
]
key of the System Check item for more than
2 seconds.
The Erase Code screen appears.
3-4. Enter the Personal Code currently set by
touching the [
0
] to [
9
] keys, then touch and
hold the [
ENT
] key for more than 2 seconds.
The message “
Personal Code has been
erased
” appears, and it will return to the
previous screen.
