14
VZ509A
English
Owner
’s ma
nua
l
Adjusting the Volume
1. Press the [
VOL –
]/[
VOL +
] buttons to adjust
the volume.
[VOL –]
: Decreases the volume.
[VOL +]
: Increases the volume.
• The volume level indicated in the display is
in a range from 0 (min.) to 33 (max.).
CAUTION
CAUTION
While driving, keep the volume level at which
external sounds can be heard.
Opening the Liquid Crystal
Panel and Adjusting the
Angle
Standing up the liquid crystal panel
1. Press the [
OPEN/CLOSE
] button.
The liquid crystal panel comes out and stands
up automatically.
Note:
•
If the liquid crystal panel stops in the middle of its
operation, press the [
OPEN/CLOSE
] button to
house the panel and press the button again to
raise it. The unit will enter the same display mode
as the display was in when last turned off.
Panel calibration function
The liquid crystal panel’s maximum angle of
inclination can be adjusted to match the
installation configuration within the vehicle.
• Perform this with the panel in its housed
position.
1. Keep pressing the [
OPEN/CLOSE
] button
more than 5 seconds.
The electronic beep will be heard.
After the beep sounds twice, the panel will
come out and stand up to the maximum angle.
After completion of the calibration, the panel
will be housed into the unit automatically.
• If the panel does not strike the instrument
panel or other parts of the car during
calibration, the maximum inclination will be
110
q
.
• If the panel strikes a car part during
calibration within a range of 70
q
inclination,
the maximum downward inclination will be
70
q
.
WARNING
•
To prevent the battery from going dead,
operate this unit with the engine running
if possible.
•
When the liquid crystal panel is
operating, be careful not to get your hand
or finger caught between the panel and
main unit or the instrument panel of the
car.
•
Do not move the liquid crystal panel by
hand.
70˚
