10
5. REMOTE START OPERATION
5.1 Remote Starting
To Remote Start the System:
1. Be sure the System is not in Valet Mode.
2. Press Button 4.
• The parking lights will turn on.
• The siren will chirp 3 times (if Armed, the shock sensor will turn off).
• The ignition will turn on.
• The engine will start and run for the duration of its programmed Run Timer.*
• The heater/air-conditioner will turn on (if turned on prior to exiting the vehicle).
• The LED will double flash.
*If the engine fails to start on the first attempt, it will repeat the starting procedure 2
more times.
Turning on the ignition key then pressing the brake pedal will disengage the MS2005
and allow you to operate and drive your vehicle in a normal manner.
5.2 Shut Down
Any of the following will shut down the engine when it is under Remote Start control:
1. Press Button 4 for 3 seconds.
• After the engine shuts down the doors will lock (if installed and programmed).
2. Press the brake pedal.
3. Open the hood (or trunk if connected).
4. Remote Start Time-Out (completion of the timed run cycle).
5.3 Stop and Go
The Stop and Go Feature allows you to remove the ignition key and exit the vehicle
while keeping the engine running during short stops.
To leave the vehicle running:
1. Press the brake pedal and hold.
2. While pressing the brake pedal, push Button 4 on the Remote Transmitter for 2
seconds.
• The LED will flash rapidly.
• The parking lights will flash 5 times.
3. Release the brake pedal.
4. Remove the key from the ignition switch.
5. You may now exit the vehicle, arm the alarm and lock the doors.
MS2105 owner.qxd 8/25/2003 4:21 PM Page 10
Summary of Contents for UNGO MS2105
Page 1: ......
