2 / 3
DOC ID
– 1899 • Rev 01
2. Use a screwdriver to loosen and remove the screw, setting
it aside for resealing the sensor.
3.
Slide a fingernail/fingertip into the keyfob’s bottom slot
(area with the keychain protruding), and then push the
keyfob’s back casing upward and away from the front of
the keyfob.
Note:
The keychain will come lose in this process, be
careful not to lose the keychain.
4. Hold the circuit board to the front casing.
Note:
Do not move the circuit board, if the board is moved
it may result in improper button reporting.
5. Use a fingernail/fingertip to push the battery out of the
casing, noting the polarity of the battery.
6. Slide a new CR2032 battery into the battery casing,
making sure that the polarity is correct.
7. Place the keychain back onto the screw post, and then
press the keyfob
’s backplate into place.
8. Place the screw into the screw hole, and then fasten the
screw into the keyfob.
9. Test the keyfob.
Specifications
Compatible panel
ClareOne
Transmitter frequency
433MHz TX
Encrypted
Yes
Buttons
4 Buttons
•
Away
•
Stay
•
Disarm
•
SOS
LED indication
1 LED (red)
Battery type
CR2032 (220mAh)
Battery life
5 years
Sensor dimensions
(W × H × D)
1.49 × 2.53 × .55 in.
(38 × 64.5 × 14 mm)
Operating environment
Temperature
Relative humidity
32 to 122.6°F (0 to 50°C)
85% max
Water resistant
IPX4
Regulatory information
Manufacturer
Clare Controls, Llc.
7519 Pennsylvania Ave, Suite 104
Sarasota, FL 34243
North American
standards
ETL listed to: UL 1023, ULC 1023
FCC compliance
FCC ID: 2AVDC-XPD-201
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the
equipment and receiver.
-- Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
Warning: changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s authority to operate the
equipment.
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with minimum distance 20cm
between the radiator and your body.
