Claas LEXION 770 2016, Information And Basic Field Settings

Page: 24 / 48

23
De-activating the CRUISE PILOT
To de-activate the CRUISE PILOT either move the control lever with a jerk or give a
short firm press on both footbrake pedals.
Also in the CRUISE pilot menu in CEBIS turn the master switch to “OFF” and this will
prevent it being accidentally engaged by pressing the button (1) on the control lever.
Cruise Control – Setting the ground speed
Engage the threshing and the cutterbar, set the engine to maximum speed and
drive into the standing crop. Move the control lever to the desired ground speed,
press and hold the button (1) shown above for 3 seconds. This will be confirmed
with a beep and the Cruise Control will be activated.
Engage threshing and the cutterbar, ensure
the engine is running at the maximum speed.
Drive into the standing crop at no less than
2km/h.
Ensure that the combine has crop going
through it and then press button (2) on the
joystick for 2 seconds. The symbols in the
HOTKEY direct menu will have the colours
inverted on activation.
Activating the CRUISE PILOT
To adjust the ground speed after it has been set use the HOTKEY (2) and the rotary
switch (4) which will change the Cruise Control value shown in the picture below.