Claas K5D00100, Repair Manual

Page: 38 / 252

AXLES & STEERING 1.28
6. Fit O-ring (6) to axle beam.
7. Using suitable lifting gear, position axle beam (7)
on brake pack and secure with bolts (8). Torque
load bolts to 320 Nm (236 lbf ft.).
8. Fit the nut (9) to the lower stud and torque load to
190 Nm (140 lbf ft.).
NOTE: When fitting bushes to the axle beam, it is
advisable to cool bushes.
9. Fit upper and lower bushes (10 & 11) to axle
beam (7) using special tool Part No, CA715039 and
a hammer.
NOTE: Only fit bush (12) if it was removed at the
dismantling operation.
10. Fit bush (12) to axle beam (7) using special tool
Part No, CA715157 and a hammer.
11. Fit sealing ring (13) to axle beam (7) using
special tool Part No, CA715402 and a hammer. Fill
¾ of the seal cavity with grease.
12. Lubricate the bush (12) and sealing ring (13)
with grease. Fit the drive shaft (14) to the axle to
engage the differential.
6. O-ring
7. Axle beam
8. Bolt
9. Nut
10. Bush
11. Bush
12. Bush
13. Sealing ring
14. Drive shaft
The axle beams is heavy. Take care
when fitting axle beam to
differential and use suitable lifting
gear. Make sure the axle beam is
fitted to the correct side of the
differential and the alignment marks
made during dismantling are lined
up.
Take care, when fitting the axle
beam, not to dislodge the brake
discs and fixed discs.