CKD ABSODEX AX1022, Manual

Page: 10 / 104

Intro 9
AX
Series
Basic settings
1. Input the program from a personal computer or interactive terminal.
2. Set required parameters the same way.
3. Set the appropriate gain.
Basic drive methods
1. Select the program to be executed from the PLC.
2. Input the start signal from the PLC.
3. The in-position signal is output from the driver after drive starts.
System configuration
SERIAL:
MODEL: AX9000GH
ABSODEX
CKD Corporation MADE IN JAPAN
MON.
POWER
F1
L1
FG
U
V
W
BK+
BK-
L2
L3
F2
F3
CN2
CN3
CN1
G1
G2
ABSODEX
POWER
3200-230 VAC
50/60HZ
Direct drive actuator
Interactive terminal
"AX0170H" (option)
RS-232C cable for communication (2m)
"AX-RS232C-9P" for D-sub 9 pin
(option)
(resolver cable)
(motor cable)
Noise filter for motor cable
If the cable is longer
than 6 m, insert a
noise filter on the
motor cable.
Cable set (standard 4m)
200 VAC three phase
Noise filter
FG
PC
Computer communication software
" Teaching note " (Free software for Windows)
RS-232C
I/O connector (MR-50LM)
AX driver power
24 VDC
I/O
Remote I/O station
PLC
Master
AX-OPX
When I/O used
When network
used
Slave unit power
AX driver power
24 VDC
PLC
Driver
Actuator
Driver (with controller)
Cable set (4m)
Accessory/I/O connector (MR-50LM), driver installation bracket
Standard configuration
Configuration
1
1
1
Name Quantity
Programming tool
• AX0170H is used as a programming terminal for S/GS and H/
GH drivers.
• "Teaching Note" software for personal computer communica-
tion is available. (Windows Version free software)
Direct drive actuator programs are created, parameters set,
and operation commands, etc., issued from the personal com-
puter. Created programs are saved.
An RS-232C communication cable is required.
Note: The communication cable is wired exclusively for a di-
rect drive actuator, so a commercial communication
cable cannot be used. The driver or personal computer
could fail if connected incorrectly.
a) for D-sub 9 pin (2m) (Model no.: AX-RS232C-9P)
b) for 14 pin half-pitch (2m) (Model no.: AX-RS232C-14P)
c) for D-sub 25 pin (2m) (Model no.: AX-RS232C-25P)