If you are using the recommended controllers, you can connect the DMX-output of the controller
directly with the DMX-input of the first fixture in the DMX-chain. If you wish to connect
DMX-controllers with other XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain
Connect the DMX-output of the frits fixture in them-chain with the DMX-input of the next fixture. Ways
connect one output with the input of the next fixture until all fixtures are connected.
CAUTION
：
At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 ohm
resistor between Signal (-) and (+) into a 3-pin XLR-plug it in the DMX-output of the last fixture.
一、DMX channel description
DMX
channel
Function
Data
Description
1
color-wheel
0..255
rotation slow-->fast
2
gobo wheel
0..255
rotation slow-->fast
3
gobo wheel
rotation
0..255
gobo angle 0°--360°
4
SHUT and Dimmer
0..255
5
pan
0..255
pan adjustment 0°--540°
6
tilt
0..255
Tilt adjustment 0°--270°
7
Pan /Tilt speed
0..255
Fast-slow
8
Reset
0..255
ADDRESSING
The Control Board on the front side of the base allow you to assign the DMX fixture the address,
which is defined as the first channel from which the light will respond to the contrllor.If you set, for
example, the address to channel 5,the light will use the channel 5 to 22 for control
Please, be sure that you don’t have any overlapping channels in order to control each the light
correctly and independently from any other fixture on the DMX data link.
7
