FITTING/EXCHANGING THE LAMP
DANGER: Install the lamp with the device switched off only. Unplug from mains before!
Open the small lamp cover by loosening the 3 Phillips screws, if changing the lamp; remove the old
lamp from the socket.
Do not install a lamp with a higher wattage! A lamp like this generates temperatures the device is
not designed for.
Damages caused by non-observance are not subject to warranty. Please follow the lamp
manufacturer
’
s notes! Do not touch the glass-bud bare-handed during the installation!
Make sure that the lamp is installed tightly into the lamp holder system.Reclose the top
cover of the head and tighten the Phillips screws. Before sticking the lamp, by pressing
the
”
UP
”
and
“
DOWN
”
buttons in one time and then confirming with the Enter-button.
RIGGING:
●
Danger to life!
●Please consider the EN 60598-2-17 and the respective national norms drums during the
installation！
The installation must only be carried out by an authorized dealer.
●
The installation of the projector has to be built and constructed in a way that it can hold 10 times the
weight for 1 hour without any harming deformation.
●The installation must always be secured with a safety attachmant,an appropriate catch
net. This secondary safety attachment must be constructed in a way that no part of the
installation can fall down if the main attachment fails.
● When rigging,derigging or servicing the fixture staying in the area below the
installation place, on bridges, under high working pluses and other endangered areas
is forbidden.
●
The operator has to make sure that safety-relating and machine-technical installations are approved by
an expert before taking into operator for the first time and after changes before taking into operation
anther time.
●
The operator has to make sure that safety-relating and machine –technical installations are approved
by an expert after every four years in the course of an acceptance test.
●The operator has to make sure that safety-relating installations are approved by a
skilled person once a year.
PROCEDURE
：
The projector should be installed outside areas where persons may walk by or be seated.
IMPORTANT
！
Overhead rigging requires extensive experience, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the projector. If you lack these qualifications, do not attempt the installation
yourself, but instead use a professional structural rigger. Improper installation can result in bodily injury
and/Or damage to property.
●
The projector has to be installed out of the reach of people.
●
If the projector shall be lowered from the ceiling or high joists, professional trussing systems have to
be used. The projector must never be fixed swinging freely in the room.
5
