CK Light 192CH DMX CONTROLLER II, User Manual

Page: 9 / 16

button for three seconds to exit program mode. The LED will go out indicating this
selection.
� � � �
Example Example Example Example Scene Scene Scene Scene Program Program Program Program
1) Program Enable.
2) Tap the Scanner 1 button to turn on its fader control.
3) Verify that the page select is set on page A, if not press the page select button to select
page A.
4) Move the first and second faders all the way up to their maximum value position.
5) Select bank 1 using the bank Up/Down buttons.
6) Press the MIDI/Rec button.
7) Tap scene 1 to store the first scene.
8) Repeat steps 4-7 until all scenes have been programmed into bank 1.
9) Tap the scanner 1 button to turn off the fader control.
10) When finished, disable program mode. You can now manually tap through you have
just programmed.
� � � �
Editing Editing Editing Editing A A A A Scene Scene Scene Scene
1) Program Enable.
2) Press the Bank Up/Down button to select the bank containing the scene you wish to
edit.
3) Select the scene you wish to edit by tapping it’s scene button.
4) Use the faders and/or joystick to make the desired adjustments to the scene.
5) Once you have completed the changes, tap the MIDI/Rec button.
6) Tap the scene button that corresponds to the scene you’re editing. This will override
the existing scene.
Be sure to select the same scene in steps 3 and 6, otherwise you may accidentally record
over an existing scene.
� � � �
Copy Copy Copy Copy Scanner Scanner Scanner Scanner Settings Settings Settings Settings – – – – This setting allows you to copy the settings of one scanner to
another
1) Press and hold down the scanner button you wish to copy.
2) While holding down the button, tap the button of the scanner you wish to copy the