CK Light 192CH DMX CONTROLLER II, User Manual

Page: 14 / 16

flash briefly indicating the requested operation has been performed.
�
�
� �
Display
Display Display
Display DMX
DMX DMX
DMX Channel
Channel Channel
Channel
1) Press the Fine and Mode buttons at the same time, putting the controller into assign
mode.
2) Press the Fine and Mode buttons again, lighting the reverse LED.
3) Press the scanner button that is set at the desired Pan and Tilt and the LCD will
display the DMX values for Pan and Tilt.
FADE
FADE FADE
FADE TIME
TIME TIME
TIME
� � � �
Fade Fade Fade Fade Time/Assign Time/Assign Time/Assign Time/Assign Fade Fade Fade Fade Time Time Time Time
1) With the power off, press the mode and Tap/Display buttons at the same time.
2) Apply the power again, tap the Tap/Display button to change between Fade Time and
Assign Fade Time, the LCD reads
3) Press the Mode and Tap/Display buttons at the same time to store your setting into
memory. If you do not wish to save your setting, press the blackout key to exit this
operation.
PLAYBACK
PLAYBACK
PLAYBACK PLAYBACK
�
�
� �
Running
Running
Running Running Scenes
Scenes
Scenes Scenes
Threr are three modes in which you can run scenes and chases. They are Manual mode,
Auto mode, and music mode.
�
�
� �
Manual
Manual
Manual Manual Mode
Mode
Mode Mode
1) When the power is turned on, the unit enters manual mode automatically.
2) Check and verify that both the Auto and Music LEDs are off.
3) Use the Bank Up/Down button to select the bank with the scenes you wish to run.
4) Press the scene button corresponding to the scene you wish to display.
�
�
� �
Auto
Auto
Auto Auto Mode
Mode
Mode Mode
This function allows you to run a bank of programmed scenes in sequence.
ALL ONLY
FD FD
CH X/Y
OR
TIME TIME