CHASES
CHASES
CHASES
CHASES
�
�
�
�
Programming
Programming
Programming
Programming a
a
a
a Chase
Chase
Chase
Chase
Note: You must have already programmed scenes in order to program a chase, this
function allows you to cycle through up to 240 scenes in a preselected order. It is
recommended before programming chases for the first time, you delete all chases in the
controller. See Delete All Chases for instructions on how to do so.
1) Enable Programming Mode.
2) Tap the Chase button to select the chase you wish to program.
3) Select a desired scene from the bank that has scenes stored inside it.
4) Tap the MIDI/Rec button.
5) Repeat steps 3-4 until all desired scenes scenes have been entered.
�
�
�
�
Inserting
Inserting
Inserting
Inserting a
a
a
a bank
bank
bank
bank of
of
of
of scenes
scenes
scenes
scenes into
into
into
into a
a
a
a chase
chase
chase
chase
1) Enable Programming Mode.
2) Select the chase you wish to program.
3) Use the Bank Up/Down key to select the bank of scenes you wish to copy.
4) Tap the Music/Bank Copy button.
5) Tap the MIDI/Rec copy button, all LEDs will flash three times indicating that the
requested operation has been performed.
�
�
�
�
Add
Add
Add
Add A
A
A
A Step
Step
Step
Step
1) Enable Programming Mode.
2) Press the corresponding button to the chase you wish to add a step to.
3) Press the Tap/Display button, the LCD will show the current step.
4) Press the Bank Up/Down button and scroll to the step you wish to insert the step
after.
5) Press the MIDI/Rec button, the segment display will read the step one step higher
than before.
6) Tap the Tap/Display buttonagain. The LCD shows the current chase, scene, and bank.
Create a desired scene and record it as a new step or select a previously programmed
scene to add to the chase.
7) Once you have selected the scene you wish to add, press the MIDI/Rec button again.
