which controls the movement. (Example: If pan is controlled by slider number 4,
press and hold the “Mode” button while tapping scene button 4#).
7) When finished press the “Mode” and “Fine” button at the same time again to exit
Assign mode.
�
�
�
�
Reverse
Reverse
Reverse
Reverse Joystick
Joystick
Joystick
Joystick Movement/DMX
Movement/DMX
Movement/DMX
Movement/DMX Channel
Channel
Channel
Channel
1) Enable Programming Mode.
2) Press the Fine and Mode buttons to enter assign mode, then press Fine and Mode
buttons again to enter reverse mode. The reverse LED lights up indicating reverse
mode is active.
3) Use Bank Up/Down button to change between the Pan and Tilt, the corresponding
LED lights indicating this selection.
4) Press the Tap/Display button to change between 8 CHANNEL and 16 CHANNEL
mode.
5) Press the scanner buttonto select the scanner.
6) While holding the mode button, press the corresponding scene button the channel you
wish to reverse. (For Example: If you are reversing the on one scanner, once you
verify that you are in reverse mode, and the Tilt LED is lit, check to see which slider
the Tilt control is on. Hold the mode button and press the scene button that is same as
the slider number for tilt. (Slider 5/Scene 5).
7) Continue steps 3-7 as needed. You may reverse a maximum of 48 channels for 12
scanners.
�
�
�
�
Delete
Delete
Delete
Delete a
a
a
a scanner
scanner
scanner
scanner of
of
of
of DMX
DMX
DMX
DMX Channels
Channels
Channels
Channels
1) Activate Assign or reverse mode.
2) Tap the scanner button to select the scanner you wish to delete.
3) Press the mode and Auto/Del buttons at the same time. All LEDs will flash three time
indicating the requested operation has been performed.
�
�
�
�
Clear
Clear
Clear
Clear All
All
All
All DMX
DMX
DMX
DMX Channels
Channels
Channels
Channels
1) Turn the power to the unit off.
2) Press the Mode and Auto/Del buttons at the same time.
3) While holding the two buttons, turn the power back on to the unit. All LEDs will
