— 19 —
3.3 Opening and Closing Front Cover
1.
Apply your fingers onto the concaved places
located at the right and left sides of the front
cover and pull the cover in the direction of arrow.
The cover opens about 150° downward.
2.
When closing the cover, firmly hold and press
the front cover. When closing, make sure paper
is not loosened. Loosened paper may result in
paper jam, etc.
Front cover
3.4 Setting Paper
1.
Apply your fingers onto the concaved places located at both sides of the
front cover and pull the front cover.
2.
Open the front cover by about 15°, and the cutter unit is disengaged allowing
the paper holder to appear.
3.
Confirm the direction of paper roll and put the paper onto the paper holder.
4.
Close the front cover with the paper front edge fed about 5 cm from the
upper surface of the case.
CAUTION!
■
Do not open the front cover while the printer is in operation.
■
Use the specified paper. Using paper not specified may cause poor print quality, shorter
printer life, etc.
■
Set the paper straight without looseness.
■
The print head is hot immediately after printing. DO NOT touch it with your hand.
■
Hold the printer cover at its both sides and close it firmly. Holding the front cover at
one side may result in poor closing causing uneven printing.
■
When closing the front cover, avoid pinching a finger.
■
Be careful not to touch the cutter fixed blade and manual cutter with your finger.
Front cover
Paper holder
