Citizen CBM-920II, User Manual

Page: 24 / 58

— 21 —
4.9 Memory Switch Setting
<Memory Switch Initial Setting>
NO. Item Japan (920JPN) International (920Intl)
0 International character selection Japanese U.S.A
1 Code page selection 920 emulation (Japan) 920 emulation (International)
2 Emulation selection CBM920 emulation
3 Ack timing *2 After clearing BUSY (After)
Communication error data processing *3 Replace with 7Fh (7Fh)
4 Paper-near-end selection Valid
5 Power ON state Online
6 Busy signal clear timing *1 CBM-920
7 Input buffer size 2k bytes
8 PE output at PNE *2 Valid
Communication data bit length selection *3 8 bits
9 I/F, LED state at PNE I/F+LED
A BUSY at FEED switch ON Invalid
B Auto loading Valid (short)
C Clear after auto loading FEED SW
D Supply voltage check Only at power ON
E Paper lamp CBM920 emulation
*1: Effective only for parallel I/F (P model).
*2: Applicable to parallel I/F (P model).
*3: Applicable to serial I/F (R model).
Memory switch setting can be changed by a command or by manual operation.
a) Change by command
Memory switch can be changed by a command. For details, refer to “8.
Print Control Function”.
When the printer receives the command, it outputs a BUSY signal and enters
memory setting mode. After writing into memory switch, software resetting
is carried out and the receive buffer/print buffer are cleared causing each
set value to return to the initial value and then the contents of the memory
switch(es) are reloaded.
Commands are set one by one. Use care when changing two or more set
values.