Citizen CBM-272, User Manual

Page: 23 / 157

— 4 —
2.2 Basic Specifications
Printing system
Printing width
Dot density
Paper feed pitch
Printing speed
Printing columns and
character size
Line interval
Character types
Character code
Bar code type
Paper
(See Paper Specifications)
Interface
Input buffer
Download characters
Auto-loading
Paper end function
Paper near end function
Printing color
Battery
No. of printable lines
Power save and auto
power off
Line thermal dot printing
48 mm (384 dots/line)
8 dots/mm (Width, Length)
0.125 mm
Approx. 11 lines/sec. (At maximum)
32 columns (12 x 24 Font A) 1.25 x 3.00 mm
42 columns (9 x 24 Font B) 0.88 x 3.00 mm
Initial value: 4.23 mm (1/6 inch)
Can be set with a command (1/360 inch at minimum)
Alphanumeric characters, symbols, international characters
(Choose from 10 countries)
Domestic characters, IBM characters #2 (Choose either)
UPC-A/E, JAN (EAN) 13-/8-column, ITF, CODE 39, CODE 128, CODABAR
Thermal paper roll : 58 + 0/- 1 mm x ø83 (max.) mm, 60~75µm thick
Serial (RS-232C), Parallel (CENTRONICS compliant)
2 KB
Font A, B: 95 characters each
Provided (Can be enabled/disabled with the DIP switch)
Provided
Provided (Can be enabled/disabled with the DIP switch)
Capable of printing in two colors (red/black) with the special thermal
paper.
Battery pack: 6HR-AAU-CBM (7.2 VDC, 1650 mA/h)
Ni-MH (pack of 6 AA dry cells, connectable to charger circuit via
connector)
Charging time: Approx. 5.5 hours (to full charge)
Charging monitor: POWER lamp (Red) lit in charging, goes off when
fully charged.
Recharging cycles: Over 300 cycles (at room temperature)
Charger: Built in the CBM-272 Printer.
Charger power supply: Power adapter (27AD)
The printer can be powered while the batteries are charging (floating).
Discharge control: Low voltage alarm=5.9 V, discharge termination
voltage=5.6 V, monitored by signal output and POWER lamp (Green).
Approx. 30,000 lines and more (continuous sliding print of ANK,
standard print density, at room temperature)
To save battery consumption, the printer automatically enters the power
save mode if it receives no print data, or not operated, for approx. 10
minutes. If the same inactive state continues for another 10 minutes, the
auto power off feature automatically turns the printer off. (The timer
intervals can be set with a DIP switch.)
To turn the printer on again, temporarily set the POWER switch to OFF,
then set it back to ON. All data will initialize when the printer repowers.
The power save and auto power off features are left disabled when the
printer is powered from the AC adapter.
Model
Item
CBM-272-RF120
CBM-272-PF120 CBM-272-RF230
CBM-272-PF230