9
TOW/RUN SWITCH (available for Curtis 1268 controller)
Before operating the vehicle, make sure the TOW/RUN switch is on the ‘RUN’ position.
Make sure the TOW/RUN switch is on the ‘TOW’ position if towing or pushing the vehicle.
The TOW/RUN switch is located under the dashboard as shown in the pictures below.
NOTE:
When the TOW/RUN switch is on the ‘RUN’ position, the vehicle will beep when pushed, to remind
you to stop.
WARNING!
Whenever the TOW/RUN switch is moved from the RUN position to the TOW position, please move
it back to the RUN position, there is a delay of approximately 30 seconds before the vehicle will run.
COMBINATION SWITCH:
The combination switch includes a left lever and a right lever: The left lever of the switch is used to switch
on/off the lighting system including headlight, front turn signal, rear turn signal, taillight; the right lever is to
control the wiper and horn. (Fig 1 for LE style vehicle, Fig 2 for SE style vehicle)
Fig.1 Fig.2
Left lever:
It’s used to control the lights including headlight, taillight and turning light.
1) Turn the top button to power on the headlight; and turn back to power off the headlight and taillight.
2) Push the lever up to engage the right turning light when planning to turn and drive the vehicle to the right.
3) Pull the lever down to engage the left turning light when planning to turn and drive the vehicle to the left.
Summary of Contents for Bubble Buddy
Page 5: ...5 Fig 2 Fig 3...
Page 29: ...29...
