Cissell HD170, Owner'S Manual

Page: 10 / 75

Page 10
UNPACKING/GENERAL INSTALLATION (ALL DRYERS)
This dryer is packed in a large wooden crate.
Upon arrival of the equipment, any damage in shipment should
be reported to the carrier immediately.
Upon locating permanent location of a unit, care should be taken
in movement and placement of equipment.
See outline clearance diagrams for correct dimensions.
Remove all packing material such as: tape, manuals, skid, etc.
Leveling: Use spirit level on top of dryer. The use of shims are acceptable
for this procedure.
Check voltage and amperes on rating plate before installing the
dryer.
The construction of the dryers permits installation side-by-side
to save space or to provide a wall arrangement. Position dryer
for the least amount of exhaust piping and elbows, and allow
free access to the rear of dryer for future servicing of belts,
pulleys and motors. Installation clearance from all combustable
material is 0” ceiling clearance, 0” rear clearance, and 0” side
clearance.
IMPORTANT
Opening the clothes loading door deactivates the
door switch to shut off the motors, fan, gas, steam, or
electric element. To restart the dryer, close the door
and press in the push to start button and hold briefly.
IMPORTANT
This dryer is designed for a capacity maximum load.
Overloading it will result in long drying times and
damp spots on some clothes.
IMPORTANT
Maximum operating efficiency is dependent upon
proper air curculation. The lint screen must be kept
cleaned daily to insure proper air circulation
throughout the dryer.
UNPACKING
GENERAL
INSTALLATION
(ALL DRYERS)