2-6
Cisco UCS Invicta C3124SA Appliance Installation Guide
OL-31369-01
Chapter 2 Installing the Cisco UCS Invicta C3124SA Appliance
Installing the Cisco UCS Invicta C3124SA Appliance In a Rack
Figure 2-1
Attaching a Slide-Rail Assembly
c.
Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail
assemblies are level and at the same height with each other.
d.
Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops
and lock in place.
Step 2
Insert the Cisco UCS Invicta C3124SA Appliance into the slide rails (see
Figure 2-2
):
Caution
This Cisco UCS Invicta C3124SA Appliance weighs approximately 60 pounds (28 kilograms) when
fully loaded with components. We recommend that you use a minimum of two people when lifting the
Cisco UCS Invicta C3124SA Appliance. Attempting this procedure alone could result in personal injury
or equipment damage.
Note
The inner rails are pre-attached to the sides of the Cisco UCS Invicta C3124SA Appliance at the
factory. You can order replacement inner rails if these are damaged or lost (Cisco PID
UCSC-RAIL-2U-I).
a.
Align the inner rails that are attached to the Cisco UCS Invicta C3124SA Appliance sides with the
front ends of the empty slide rails.
b.
Push the Cisco UCS Invicta C3124SA Appliance into the slide rails until it stops at the internal
stops.
c.
Push in the slide rail locking clip (item 2) on each inner rail, and then continue pushing the Cisco
UCS Invicta C3124SA Appliance into the rack until its front flanges latch onto the rack posts.
1
Front-right rack post
4
Length-adjustment bracket
2
Rear-right rack post
5
Mounting pegs (two on each end of assembly)
3
Slide-rail assembly
6
Locking clips (one on each end of assembly)
3
1
2
6
6
4
5
33
0499