Cisco UCS C220 M4, Maintaining The Server

Page: 34 / 72

3-34
Cisco UCS C220 M4 Server Installation and Service Guide
OL-32473-01
Chapter 3 Maintaining the Server
Installing or Replacing Server Components
Figure 3-16 CPU Socket
Step 7
Remove any existing CPU:
a.
With the latches and hinged CPU cover plate open, swing up the CPU in its hinged seat to the open
position, as shown in
Figure 3-16 .
b.
Grasp the CPU by the finger grips on its plastic frame and lift it up and out of the hinged CPU seat.
c.
Set the CPU aside on an anti-static surface.
Step 8
Install a new CPU:
a.
Grasp the new CPU by the finger grips on its plastic frame and align the tab on the frame that is
labeled “ALIGN” with the SLS mechanism, as shown in
Figure 3-17 .
b.
Insert the tab on the CPU frame into the seat until it stops and is held firmly.
The line below the word “ALIGN” should be level with the edge of the seat, as shown in Figure 3-17 .
c.
Swing the hinged seat with the CPU down until the CPU frame clicks in place and holds flat in the
socket.
d.
Close the hinged CPU cover plate.
e.
Clip down the CPU retaining latch with the icon, and then clip down the CPU retaining latch
with the icon. See Figure 3-16 .
1
CPU retaining latch
4
Hinged CPU seat
2 CPU retaining latch 5 Finger grips on plastic CPU frame
3 Hinged CPU cover plate
1
2
4
3
5
352941