D14642.15 Codec C40-C60 API Reference Guide TC7.0, JANUARY 2014.
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
45
Cisco TelePresence System Codec C40/C60
API Reference Guide
Logging configuration
xConfiguration Logging Mode
Not applicable in this version.
Network configuration
xConfiguration Network [1..1] IPStack
Select if the sFystem should use IPv4, IPv6, or dual IP stack, on the network interface. NOTE: After
changing this setting you may have to wait up to 30 seconds before it takes effect.
Requires user role:
ADMIN
Value space:
<Dual/IPv4/IPv6>
Dual:
When set to Dual, the network interface can operate on both IP versions at the same time,
and can have both an IPv4 and an IPv6 address at the same time.
IPv4:
When set to IPv4, the system will use IPv4 on the network interface.
IPv6:
When set to IPv6, the system will use IPv6 on the network interface.
Example:
xConfiguration Network 1 IPStack: Dual
xConfiguration Network [1..1] IPv4 Assignment
Define how the system will obtain its IPv4 address, subnet mask and gateway address. This setting
only applies to systems on IPv4 networks.
Requires user role:
ADMIN
Value space:
<Static/DHCP>
Static:
The addresses must be configured manually using the Network IPv4 Address, Network IPv4
Gateway and Network IPv4 SubnetMask settings (static addresses).
DHCP:
The system addresses are automatically assigned by the DHCP server.
Example:
xConfiguration Network 1 IPv4 Assignment: DHCP
xConfiguration Network [1..1] IPv4 Address
Enter the static IPv4 network address for the system. This setting is only applicable when Network
Assignment is set to Static.
Requires user role:
ADMIN
Value space:
<S: 0, 64>
Format:
A valid IPv4 address.
Example:
xConfiguration Network 1 IPv4 Address: "192.0.2.2"
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xConfiguration
