Data Fields
Setup
Cisco Small Business WRP400 Administration Guide
129
B
Setup > Connection Recovery
Service Type
The most commonly available type of mobile
data service connection based on your area
service signal. If your location supports only one
mobile data service, you may set up for enhance
build up connection. The first selection will
always search for HSPDA/3G/UMTS service or
switch to GPRS automatically only when it is
available.
Recovery & Failover
Ethernet Connection
Recovery
When this feature is enabled, the Internet
connection is made through the Ethernet
interface if it is available. This feature also
enables the Interface Connection Failover
feature, so that a connection failure on the
Ethernet interface causes the WRP400 to
attempt to bring up the connection through the
mobile network if available. Whenever the
Ethernet Internet connection recovers, the
WRP400 automatically attempts to bring back
and recover the Ethernet Internet connection.
Ethernet Connection Recovery requires that the
Mobile Connection Mode is set to Auto and the
Ethernet interface is set to the high priority.
Interface Connection Failover
When this feature is enabled, the WRP400
detects the physical connection and/or
presence of traffic on the Internet link. If the link
is idle for some time, the WRP400 attempts to
ping a destination. If the ping does not reply, the
WRP400 assumes the link is down and attempts
to fail over to another interface.
This feature is automatically enabled if Ethernet
Connection Recovery is enabled.
Timeout
Specify the time interval at which the WRP400
detects the status of the Internet connection.
Default: 60 seconds
