Advanced Voice Fields
Regional page
Cisco Small Business WRP400 Administration Guide
80
A
Voice tab > Regional page >
Vertical Service Activation Codes section
Vertical Service Activation Codes are automatically appended to the dial-plan.
There is no need to include them in dial-plan, although no harm is done if they are
included.
Ccomputer Delay
Delay in seconds after caller hangs up when the WRP400
starts removing the tip-and-ring voltage to the attached
equipment of the called party. Range: 0–255 seconds. This
feature is generally used for answer supervision on the
caller side to signal to the attached equipment when the
call has been connected (remote end has answered) or
disconnected (remote end has hung up). This feature
should be disabled for the called party (in other words, by
using the same polarity for connected and idle state) and
the Ccomputer feature should be used instead.
Without Ccomputer enabled, reorder tone will is played
after a configurable delay. If Ccomputer is enabled, dial
tone will be played when tip-to-ring voltage is restored
Resolution is 1 second.
The default is
2
.
Ccomputer
Duration
Duration in seconds for which the tip-to-ring voltage is
removed after the caller hangs up. After that, tip-to-ring
voltage is restored and dial tone applies if the attached
equipment is still off-hook. Ccomputer is disabled if this
value is set to 0. Range: 0 to 1.000 second. Resolution is
0.001 second.
The default is
0
(Ccomputer disabled).
Call Return Code
This code calls the last caller.
The default is
*69
.
Call Redial Code
Redials the last number called. .
The default is
*07
.
Blind Transfer Code Begins a blind transfer of the current call to the extension
specified after the activation code.
The default is
*98
.
