Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
5-20
OL-7826-05
•
On-Failure behavior
— Determines the behavior of the
SCE 2000
upon failure, or reboot.
One of the following link modes may be chosen for the
SCE 2000
in the cases of failure or
reboot.:
•
Bypass — traffic is bypassed using the internal bypass card.
•
Cutoff — the link is forced down.
•
Admin status after abnormal reboot
— This parameter determines whether the
SCE 2000
returns to full operational mode after abnormal (not user-requested) boot, or stays in non-
operational mode, in which the
SCE 2000
behaves as in failure mode. This parameter can be
set to one of the following:
•
Operational
•
Non-operational
The procedure described below is a presentation of all the questions in the topology configuration.
In actual practice, all questions may not be presented for a particular configuration, depending on
the topology deployed.
Study the examples that follow to understand the procedure for various topologies.
To configure topology dependent parameters, complete the following steps:
Step 1
Enter the topology configuration menu.
Would you like to enter the Topology configuration menu? [no]: y
Type
y
and press
Enter
.
The topology configuration dialog begins.
Step 2
Specify the connection mode.
•
To define i
nline
connection mode, press
Enter
.
•
To define
receive-only
connection mode, type
2
and press
Enter
.
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]:
Step 3
Specify the deployment type.
•
To specify a
Single-SCE Platform
deployment, press
Enter
.
•
To specify a
Cascade
deployment, type
y
and press
Enter
.
Is this a cascade deployment? [no]:
Step 4
Specify the physically-connected-link index.
•
To specify
link-0
, press
Enter
.
•
To specify link-1, type 1 and press Enter.
