Cisco Nexus 3550-T, Hardware Installation Manual

Page: 12 / 48

Statement 1017— Restricted Area
This unit is intended for installation in restricted access areas. A restricted access area can be accessed by
skilled, instructed, or qualified personnel.
Warning
Statement 1030— Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Only a skilled person or an instructed person should be allowed to
install, replace, or service this equipment.
Personnel
1. Access This unit is intended for installation in restricted access
areas. A restricted access area can only be accessed by skilled,
instructed or qualified personnel.
2. GPS To reduce the risk of electric shock, the shield of the coaxial
cable must be connected to the building earth.
Do not locate the antenna near overhead power lines or
other electric light or power circuits, or where it can
come into contact with such circuits. When installing
the antenna, take extreme care not to come into contact
with such circuits, as they may cause serious injury or
death. For proper installation and grounding of the
antenna, please refer to national and local codes (e.g.
U.S.: NFPA 70, National Electrical Code, Article 810,
Canada: Canadian Electrical Code, Section 54). Caution
3. Ambient temperature Make sure the ambient temperature does
not exceed the maximum ambient temperature allowed for the Cisco
Nexus 3550-T Programmable Switch Platform (104F, 40C). If
installed in a closed or multi-unit rack assembly, the ambient
temperature of the rack during operation will be greater than room
ambient.
4. Air flow Install the Nexus 3550-T in the rack in a way that provides
sufficient air flow for safe operation.
5. Mechanical loading Mount the Nexus 3550-T in the rack with a
mechanical load that is evenly distributed and not excessive.
6. Circuit overloading Ensure that no overloading of the circuits
occurs which might affect overcurrent protection and supply wiring.
The ratings are provided on the unit.
7. Earthing
Ensure that the rack-mounted equipment is earthed reliably.
Consider using supply connections other than direct connections
to the branch circuit (e.g. use of power strips).
Environment
Cisco Nexus 3550-T Hardware Installation Guide
8
Installing the Chassis
Safety