Figure 32: Installing a LC in NCS 4016
Procedure
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the two ESD jacks located
on the front or rear side of the chassis. You can also connect the ESD-preventive wrist strap leash to any bare
metal surface on the chassis.
Step 2
Remove the card from its antistatic packaging.
To prevent ESD damage, handle a card by its ejector lever (s) or the card carrier edges only. Do not
touch any of the electrical components, pins, or circuitry.
Caution
Step 3
Orient the card:
• If you are inserting the RP or LC into the card cage of NCS 4009 or the upper card cage in NCS 4016,
the arrows on the OIR buttons should be facing up.
To orient the FC card in FC slots of NCS 4009, the ejector button should be facing down.
Note
Hardware Installation Guide for the Cisco NCS 4000 Series
42
Installing Route Processor Cards, Fabric Cards, and Line Cards
Installing a Route Processor, Fabric Card, or Line Card
Summary of Contents for NCS 4000 Series
Page 2: ......
