Cisco ME 3600X, Command Reference Manual

Page: 233 / 628

2-209
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
police
Defaults
No policers are defined.
Conform burst ( bc ) is automatically configured to 250 ms at the configured CIR.
Command Modes Policy-map class configuration
burst-ms (Optional) Specifies the normal burst size in milliseconds. The range is 1 to
2000.
bc burst-ms (Optional) Specifies the conformed burst (bc) in milliseconds. The range is
1 to 2000.
pir pir-bps (Optional) Specifies the peak information rate (PIR) for the policy. The range
is 64000 to 10000000000. This parameter is used for configuring a 2-rate,
3-color policer. If you do not enter a
pir pir-bps , the policer is configured as
a 1-rate, 2-color policer.
be burst-bytes (Optional) Specifies the peak burst size in bytes. The range is 8000 to
16000000 bytes. The default is internally calculated based on the user
configuration. You cannot configure this option unless you have entered the
pir keyword.
pir percent percent Specifies the PIR as a percentage of the bandwidth assigned to the class. The
range is from 1 to 100 percent. if you enter
cir percent , you must enter pir
in percent.
be burst-ms (Optional) Specifies the peak burst in milliseconds. The range is 1 to 2000.
conform-action (Optional) Specifies the action to perform on packets that conform to the CIR
and PIR. The default is
transmit .
drop (Optional) Drops the packet.
set-cos-transmit
new-cos-value
Set a new class of service (CoS) value for the packet and send the packet. The
range for the new CoS value is 0 to 7.
set-discard-class-trans
mit
new discard-value
Sets a new discard-class value for the packet and send the packet. The range
for the value is 0 to 7.
set-dscp-transmit
new-dscp-value
Sets a new Differentiated Services Code Point (DSCP) value for the packet
and send the packet. The range for the new DCSP value is 0 to 63.
set-mpls-exp-topmost
transmit
new-topmost-exp-value
Sets an MPLS label using the new MPLS EXP value at tag imposition, and
send the packet. The range is 0 to 7.
set-mpls-exp-topmost
transmit
new-topmost-exp-value
Sets an MPLS label using the new MPLS EXP value for the topmost (outer)
MPLS label, and send the packet. The range is 0 to 7
.
set-prec-transmit
new-precedence-value
Sets a new IP precedence value for the packet and send the packet. The range
for the new IP precedence value is 0 to 7.
set-qos-transmit
qos-group-value
Sets a new quality of service (QoS) group value for the packet and send the
packet. The range for the new QoS value is 0 to 99.
transmit (Optional) Sends the packet unmodified.
exceed-action (Optional) Action to be taken for packets that exceed the CIR but are less
than or equal to the PIR.
violate-action (Optional) Action to be taken for packets exceed the PIR.