Cisco ME 3600X, Command Reference Manual

Page: 147 / 628

2-123
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
ip sla schedule
ip sla schedule
To configure the scheduling parameters for a single Cisco IOS IP Service Level Agreements (SLAs)
operation, use the ip sla schedulecommand in global configuration mode. To stop the operation and place
it in the default state (pending), use the no form of this command.
ip sla schedule operation-number [ life { forever | seconds }] [ start-time { hh : mm [ : ss ] [ month day
| day month ] | pending | now | after hh : mm : ss }] [ ageout seconds ] [ recurring ]
no ip sla schedule operation-number
Syntax Description
Defaults
The operation is placed in a pending state (that is, the operation is enabled but not actively collecting
information).
Command Modes
Global configuration
Command History
operation-number Number of the IP SLAs operation to schedule.
life forever (Optional) Schedules the operation to run indefinitely.
life seconds (Optional) Number of seconds the operation actively collects information. The
default is 3600 seconds (one hour).
start-time (Optional) Time when the operation starts.
hh : mm [ : ss ] Specifies an absolute start time using hour, minute, and (optionally) second. Use
the 24-hour clock notation. For example, start-time 01:02 means "start at 1:02
a.m.," and start-time 13:01:30 means "start at 1:01 p.m. and 30 seconds." The
current day is implied unless you specify a month and day.
month (Optional) Name of the month to start the operation in. If month is not specified,
the current month is used. Use of this argument requires that a day be specified. You
can specify the month by using either the full English name or the first three letters
of the month.
day (Optional) Number of the day (in the range 1 to 31) to start the operation on. If a
day is not specified, the current day is used. Use of this argument requires that a
month be specified.
pending (Optional) No information is collected. This is the default value.
after hh : mm : ss (Optional) Indicates that the operation should start hh hours, mm minutes, and ss
seconds after this command was entered.
ageout seconds (Optional) Number of seconds to keep the operation in memory when it is not
actively collecting information. The default is 0 seconds (never ages out).
recurring (Optional) Indicates that the operation will start automatically at the specified time
and for the specified duration every day.
Release Modification
15.2(4)S1 This command was introduced.