4-4
Cisco IR829 Integrated Services Router
Chapter 4 Initial Configuration
Verifying the Initial Configuration
After the initial configuration file is created, you can use the Cisco IOS CLI to perform additional
configuration.
Verifying the Initial Configuration
To verify that the new interfaces are operating correctly, perform the following tests:
•
To verify that the interfaces and line protocol are in the correct state—up or down—enter the
show
interfaces
command.
•
To display a summary status of the interfaces configured for IP, enter the
show ip interface brief
command.
•
To verify that you configured the correct hostname and password, enter the
show configuration
command.
After you complete and verify the initial configuration, you can configure your Cisco router for specific
functions.
Where To Go From Here
There are a wide variety of configuration options available on the Cisco IR829. The rest of this chapter
will discuss different pieces of documentation to refer to, as well as point out the differences between
this device and the rest of the 800 series routers.
800 Series Documentation
The home for all of the 800 series router documentation is here:
http://www.cisco.com/c/en/us/support/routers/800-series-routers/tsd-products-support-series-home.ht
ml
Most of the Cisco IR829 configuration tasks are available in the Cisco 800 Series Integrated Services
Routers Software Configuration Guide:
http://www.cisco.com/c/en/us/td/docs/routers/access/800/software/configuration/guide/SCG800Guide.
htm
Some common tasks between the Cisco 800 series and the Cisco IR829 are listed here:
Configuring Wireless Devices
Cisco 4G LTE Software Installation Guide
