2-2
Cisco IR829 Integrated Services Router Hardware Installation Guide
Chapter 2 Installing the Router
Equipment, Tools, and Connections
Warning
This product is not intended to be directly connected to the Cable Distribution System. Additional
regulatory compliance and legal requirements may apply for direct connection to the Cable
Distribution System. This product may connect to the Cable Distribution System ONLY through a
device that is approved for direct connection.
Statement 1078
Equipment, Tools, and Connections
This section describes the equipment, tools, and connections necessary for installing your Cisco IR829.
It contains the following topics:
•
Items Shipped with your Router, page 2-2
•
•
Items Shipped with your Router
Unpack the box and verify that all items listed on the invoice were shipped with the Cisco IR829.
The following items are shipped with your router:
•
Getting Started Guide Part Number 78-100611
•
Power Cable components
•
Grounding Lug
•
Ethernet Cable Part Number 75-1501-01
Additional Items
The following items are not shipped with the router but are required for installation:
•
ESD-preventive cord and wrist strap.
•
Screws for mounting the router on a wall.
•
Two number-10 wood screws (round- or pan-head) with number-10 washers or two number-10
washer-head screws, for mounting on a wall stud. The screws must be long enough to penetrate at
least 3/4 inch (20 mm) into the supporting wood or metal wall stud.
•
Two number-10 wall anchors with washers, for mounting the router on a hollow wall.
•
Wire crimper for chassis grounding.
•
Wire for connecting the chassis to an earth ground.
•
AWG 14 (2 mm2) or larger wire for NEC-compliant chassis grounding.
•
AWG 18 (1 mm2) or larger wire for EN/IEC 60950–compliant chassis grounding.
•
Ethernet cables for connecting to the Fast Ethernet (FE) WAN and LAN ports.
•
Ratcheting torque flathead screwdriver that exerts up to 15 in-lb (1.69 N-m) of pressure.
•
A number-2 Phillips screwdriver.
