67
Configuring the Switch with the CLI Setup Program
Entering the Initial Configuration Information
ip address 10.4.120.106 255.0.0.0
!
interface FastEthernet1/0/1
!
interface FastEthernet1/0/2
interface FastEthernet1/0/3
!
...<output abbreviated>
end
10.
These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, select option 2 to
save it in NVRAM.
Enter your selection [2]:
2
Make your selection, and press
Return
.
After you complete the setup program, the switch can run the default configuration that you created. To change this
configuration or to perform other management tasks, enter commands at the
Switch>
prompt
.
