65
Configuring the Switch with the CLI Setup Program
Entering the Initial Configuration Information
2.
Click
Next
.
3.
When the InstallShield Wizard for Cisco Virtual Com appears, click
Next
.
4.
When the Program Maintenance window appears, select the
Remove
radio button.
5.
Click
Next
.
6.
When the Remove the Program window appears, click
Remove
.
If a User Account Control warning appears, click
Allow - I trust this program to proceed
.
7.
When the InstallShield Wizard Completed window appears, click
Finish
.
Entering the Initial Configuration Information
To set up the switch, you need to complete the setup program, which runs automatically after the switch powers on. You
must assign an IP address and other configuration information necessary for the switch to communicate with the local
routers and the Internet.
IP Settings
You need this information:
Switch IP address
Subnet mask (IP netmask)
Default gateway (router)
Enable secret password
Enable password
Telnet password
Completing the Setup Program
Follow these steps to complete the setup program and to create an initial configuration for the switch:
1.
Enter
Yes
at these two prompts.
Would you like to enter the initial configuration dialog? [yes/no]:
yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]:
yes
2.
Enter a host name for the switch, and press
Return
.
