Cisco Media Gateway Controller Release 9 Regulatory Compliance and Safety Information
FCC Class A Compliance
46
Cisco Media Gateway Controller Software Release 7 Installation and Configuration Guide
FCC Class A Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case users will be
required to correct the interference at their own expense.
You can determine whether your equipment is causing interference by turning it off. If the interference
stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment
causes interference to radio or television reception, try to correct the interference by using one or more
of the following measures:
•
Turn the television or radio antenna until the interference stops.
•
Move the equipment to one side or the other of the television or radio.
•
Move the equipment farther away from television or radio.
•
Plug the equipment into an outlet that is on a different circuit from the television or radio. (That is,
make certain the equipment and the television or radio are on circuits controlled by different circuit
breakers or fuses.)
Modifications to this product not authorized by Cisco Systems, Inc. could void the FCC approval and
negate your authority to operate the product.
Declaration of Conformity
The Declaration of Conformity (DoC) is issued for each type, model, or family of products and identifies
certified equipment for European Union (EU) applications. This declaration means that the equipment
meets common technical regulations and/or normative standards for operational and safety
requirements.
To receive Declarations of Conformity and other product approvals by the manufacturer for each product
found to be compliant with the applicable directive(s), access the World Wide Web at
http://www.cisco.com and follow the steps below:
1.
Click the login field located in the upper portion of the Cisco Connection Online banner.
2.
Under the Products & Technologies sub-section, click Products.
3.
Scroll down to Additional Information and click Product Approval Status.
Note
Now you can request Declarations of Conformity over the phone or on the web and have them
faxed to you with our new Fax on Demand service."
4.
Click the Declaration of Conformity button and the Request a Fax page is displayed.
5.
Click "Request a fax of Compliance Documentation," fill in the form, and submit. You should
receive your fax or email within 1 hour.
