Cisco DMP 4305G, User Manual

Page: 100 / 122

12-2
User Guide for Cisco Digital Media Player Device Manager 5.2.x
OL-15764-03
Chapter 12 File Storage
Procedures
Performance Guidelines for Local Storage
We recommend that you do not upload files to the /tmp/ftproot subdirectory. Instead, use
/tmp/ftproot/usb_1 .
If you upload files to /tmp/ftproot accidentally, and then DMP performance suffers, you can restore your
DMP to its normal operating condition easily. Just unplug it, wait 15 seconds, and then plug it in again.
Note
This method deletes the files that you uploaded.
Local Storage Restrictions for DMP 4310G
A DMP 4310G that uses an attached USB storage volume might corrupt or erase data on this attached
volume. Likewise, a DMP 4310G might lose its ability to mount this attached volume. After the DMP
reaches this general state, it sometimes reports incorrectly that the attached volume is still mounted
and working.
These problems can occur when you disconnect the external volume from the upper USB interface on a
DMP 4310G and then, without any delay, plug it immediately into the lower USB interface on the same
DMP. However, these problems do not occur in every such case. In our tests, they occurred
approximately 1 percent of the time.
To reduce your possible exposure to these problems, wait no less than 3 seconds after you connect or
disconnect an attached volume, before you do the reverse. In our tests, this best practice eliminated
the risk.
Restart the DMP if it merely unmounts its attached volume.
There is no workaround after the attached volume is erased or its data becomes corrupted. All that you
can do after the fact is reformat the volume and restore its data from a recent backup.
Procedures
•
Define Storage Settings, page 12-2
Define Storage Settings
•
Manage Permissions for Internal Storage, page 12-2
•
Mount or Unmount a Network Share, page 12-3
Manage Permissions for Internal Storage
You can set the permissions for internal storage in your DMP.
Procedure
Step 1
Click Internal Storage in the Settings list.
Step 2
View or edit the values, then click Apply .