Cisco D9887B, Installation And Configuration Manual

Page: 226 / 290

Appendix A
Error/Event List
202 78-4043743-01 Rev A
Error or Event List
General

Bitrate Error - The TS bitrate is not within 100 bps of 19.392 Mbps while using
the 310M card, or it is greater than 160 Mbps while using ASI.

Tuner Lock Error – The FEC is not synchronized. Data on carrier is not
synchronized.

Video Unsupported Profile/Level - The video is not of a supported
profile/level.

Carrier Lock Error - Cannot detect the carrier signal.

TS Rate Invalid - A burst of packets caused the receive FIFO to overflow.

Not Receiving Packet s - The card is not receiving IP packets within 1 FEC period
(1 second).

No TS Present Erro r - There is no sync byte (0x47) found in a 1 second period.

Transport Packet Error - There was an error in the transport stream.

Lock Error - A carrier cannot be found.

Low MER - The MER is lower than the threshold set by the user.

Low Level - The signal level is lower than the threshold set by the user.

System Time Event – If the unit is powered on/off, the time is manually
updated, or the time server is invalid, this event will be triggered.

CA Service Not Found - The CAM is configured to use selected PIDs, but the
selected PID is no longer available in the PMT.

Program Not Found – The Program / Service that is selected is not available.

Band Frequency Error – The Satellite Receiver tuning using Frequency and
Offset is not within the Receiver’s tuning range.

FP Login Error Event – There was an attempt to unlock that front panel using
the wrong password.

All SDI Jacks Squelched Error – The Manual Format does not match the SDI
Output Format for both Output A and Output B.

Uncorrectable FEC Error Event – There was an FEC error that was
uncorrectable.

Corrected FEC Error Event – There was an FEC error that was corrected.