Cisco D9887B, Installation And Configuration Manual

Page: 200 / 290

Chapter 5 Using the Web Client to Configure the D9887B Receiver
176 78-4043743-01 Rev A
3 A new window will pop up in the middle of the screen. Use the drop-down
menu at the top to choose the "Lookup Mode."
4 Use the next drop-down box to choose the desired "ID Timeout" (in seconds).
5 Enter a "Manual Station Name," and then click the Apply button to save the
changes.
Note: If no source is found in the allotted time, the "Manual Station Name" is
displayed.
Output Setup
All of the installed output option cards are listed under the "Outputs" heading. This
section includes the options for the installed output cards (e.g. Video, Audio).
Each output card can be configured by clicking on the Window button that is next to
it. When the Window button is clicked, it will bring up another window, in the
middle of the screen, with the specific options for that card. Use the drop-down
menus and input boxes to complete the edit form. Click the
Apply button, at the
bottom of the form, to save the settings. The current settings for any of the output
cards can be verified by clicking on the
Down Arrow button next to the desired
output.
PSIP Information
To view the PSIP information for the applied TS, select the RDS ( RDS 1 or RDS 2 )
and then click the View PSI Tables button which is located right next to the "Inputs"
heading towards the top of the page.
This will open a new window that displays all of the PSIP information for the
applied TS. The PSIP Tables are grouped into "MPEG", "ATSC", and "DVB" tables.
The table groups are selected using the selection radio buttons:
MPEG , ATSC , or
DVB .
The MPEG table grouping includes displaying the PAT, PMT or CAT. Click the tabs
at the top of the window to view the corresponding table.