Cisco D9865, Installation And Operation Manual

Page: 144 / 260

5-24 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C
Setting up Dish Presets,
Continued
5. Set the Local Oscillator Frequency #1 ( LO Freq 1 ), which sets the satellite
antenna LNB local oscillator #1 frequency. For C-Band application, set to 5.15
GHz. For Ku-band single LNB, enter LO Freq and set LO Freq 2 and Crossover
Frequency to 0.0. For Ku-band dual LNB, enter LO Freq 1, LO Freq 2 and
Crossover Frequency. The default is 10.75 GHz.
6. Set the Local Oscillator Frequency #2 ( LO Freq 2 ), which sets the satellite
antenna LNB local oscillator #2 frequency. This option is only used in dual-band
LNB applications. LO Freq 2 must be greater than LO Freq 1. The default is 0.0
GHz.
7. Enter the Crossover . This is an internal threshold frequency used for selecting
the LO1 or LO2 frequency, depending on the current downlink frequency
settings. This option is only used in dual-band LNB applications. The default is
0.0 GHz.
8. Enable or disable the Digital Satellite Equipment Satellite Control ( DiSEqC ).
Note: This must be enabled to control the DiSEqC switch. LNB Power must be
on to use this setting. Refer to http://www.eutelsat.com/satellites/4_5_5.html
for more information.
9. In the DiSEqC Switch drop-down list, select a port on the LNB switch, if used
(Off, A to P).
10. Click Apply to Preset .