Do not remove the optical bore dust
plugs.
Note
Figure 31: SFP+ Module with Dust Plugs
Transmit bore
3
Dust plug
1
Receive bore
4
Bail clasp with clasp tab
2
Step 2
Check the label on the SFP+ module to verify that you have the correct model for your network.
Step 3
Find the send (TX) and receive (RX) markings that identify the top side of the SFP+ module.
On some SFP modules, the TX and RX marking might be replaced by arrowheads pointing from the SFP+
module connector (transmit direction or TX) and towards the connector (receive direction or RX).
Note
Step 4
Align the SFP+ module in front of the socket opening.
Step 5
Carefully insert the SFP+ module into the socket until you feel the connector latch into place.
Figure 32: Installing the SFP+ Module in the Supervisor PIC
Cisco Converged Broadband Routers Hardware Installation Guide
44
Installing the Supervisor in the Cisco cBR Chassis
Installing the SFP+ Modules in the Supervisor PIC
