C H A P T E R
2-1
Catalyst 4500 E-Series Switches Installation Guide
OL-13972-02
2
Preparing for Installation
Planning a proper location for the switch and the layout of your equipment rack or wiring closet is
essential for successful system operation. You should install the switch in an enclosed, secure area,
ensuring that only qualified personnel have access to the switch and control of the environment.
Equipment placed too close together or inadequately ventilated can cause system overtemperature
conditions. In addition, poor equipment placement can make chassis panels inaccessible and difficult to
maintain.
Tip
For additional information about the Cisco Catalyst 4500 E-series switches (including configuration
examples and troubleshooting information), see the documents listed on this page:
http://preview.cisco.com/en/US/products/hw/switches/ps4324/tsd_products_support_series_home.html
This chapter describes how to prepare your site for switch installation and contains these sections:
•
Safety, page 2-1
•
Site Requirements, page 2-2
•
Power Requirements, page 2-13
•
Cabling Requirements, page 2-15
•
Site Preparation Checklist, page 2-15
Safety
Safety warnings appear throughout this publication in procedures that may harm you if performed
incorrectly. A warning symbol precedes each warning statement. The warnings listed below are general
warnings that are applicable to the entire publication.
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
