3-10
Cisco Video Surveillance 4300E and 4500E High-Definition IP Camera User Guide
OL-25230-02
Chapter 3 Configuring and Managing the IP Camera
Feature Setup Windows
Pan Tilt Settings Window
The Pan Tilt Settings window provides options for configuring pan and tilt functions for the IP camera.
These functions require that the IP camera be installed with a pan/tilt mount that supports the Pelco D
protocol.
If you use a pan/tilt mount that requires RS-422 or RS-485 connections, you must connect the mount to
the IP camera through a Cisco data converter (part number CIVS-KYBD22232-B).
To display the Pan Tilt Settings window, access the configuration windows as described in the
“Performing the Initial Setup of the IP Camera” section on page 2-5
, click
Feature Setup
, then click
Pan/Tilt
.
If you change any options in this window, you must click the
Save Settings
button to save the change.
If you do not click this button, changes are not retained when you exit the window.
Save Settings
appears
at the bottom of the window. You may need to scroll down to it.
Table 3-6
describes the option in the Pan Tilt Settings window.
Automatic Reset
Check this check box if you want the corresponding output port to go back
to its default state after an event occurs.
Duration
If you checked the Automatic Reset check box, enter the amount of time, in
milliseconds, that elapses before the port goes back to its default state after
an event changes it from the default state.
Table 3-5
IO Ports Settings Window Options (continued)
Option
Description
Table 3-6
Pan Tilt Settings Window Options
Option
Description
Pan/Tilt Area
Pan and Tilt Enabled
Check this check box to enable pan and tilt operation for the IP camera.
Protocol
Display only
. Indicates the protocol for the pan/tilt functionality.
Address
Enter the logical address of the external PTZ device.
To determine this address, refer to the documentation for that device.
RS-232 Settings
Baud Rate
Choose the Baud rate value that is configured on the device that controls the
pan and tilt functions of the IP camera.
The default setting is 4800 bps.
Data Bits
Display only
. Indicates the data bits configuration for the serial port on the
IP camera.
Parity
Display only
. Indicates the parity configuration for the serial port on the IP
camera.
Stop Bits
Display only
. Indicates the stop bits configuration for the serial port on the
IP camera.
