46
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Chapter Configuring Ethernet CFM and Y.1731 Performance Monitoring on Layer 3 Interfaces
CFM Support on Routed Port and Port MEP
Router>
enable
Router#
configure terminal
Router(config)#
ethernet cfm ieee
Router(config)#
ethernet cfm global
Router(config)#
ethernet cfm domain customer level 7
Router(config-ecfm)#
service customer1101 vlan 100 direction down
Router(config-ecfm-srv)#
continuity-check
Router(config)#
interface gigabitethernet 0/2
Router(config-if)#
ethernet cfm mep domain customer mpid 100 service customer1101
Router(config-if-ecfm-mep)#
interface gigabitethernet 0/2.1
Router(config-subif)#
encapsulation dot1q 100
Router(config-subif)#
end
Verifying the Ethernet CFM Configuration for Single-Tagged Packets
Use the following commands to verify Ethernet CFM configured for single-tagged packets:
•
show ethernet cfm domain
•
show ethernet cfm maintenance-points local
•
show ethernet cfm maintenance-points remote
•
show ethernet cfm error configuration
Use the
show ethernet cfm domain
command to display the maintenance point domains configured in
the network. In the following example, customer, enterprise, and carrier maintenance point domains are
configured:
Router#
show ethernet cfm domain
Domain Name: customer
Level: 7
Total Services: 1
Services:
Type Id Dir CC CC-int Static-rmep Crosscheck MaxMEP Source MA-Name
Vlan 100 Dwn Y 10s Disabled Disabled 100 Static customer1101
Domain Name: enterprise
Level: 6
Total Services: 1
Services:
Type Id Dir CC CC-int Static-rmep Crosscheck MaxMEP Source MA-Name
Vlan 110 Dwn Y 10s Disabled Disabled 100 Static custservice
Domain Name: carrier
Level: 2
Total Services: 1
Services:
Type Id Dir CC CC-int Static-rmep Crosscheck MaxMEP Source MA-Name
Vlan 200 Dwn Y 10s Disabled Disabled 100 Static carrier
Router#
Use the
show ethernet cfm maintenance-points local
command to view the local MEPs. The following
is a sample output of the
show ethernet cfm maintenance-points local
command:
Router#
show ethernet cfm maintenance-points local
--------------------------------------------------------------------------------
MPID Domain Name Lvl MacAddress Type CC
Ofld Domain Id Dir Port Id
MA Name SrvcInst Source
EVC name
--------------------------------------------------------------------------------
100 customer 7 70ca.9b4d.a400 Vlan Y
