111
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Chapter Configuring Backup Data Lines and Remote Management
Configuring Dial Backup and Remote Management Through the Console Port or Auxiliary Port
Step 3
exit
Example:
Router(config-dhcp)# exit
Router(config)#
Exits DHCP pool configuration mode and
enters global configuration mode.
Step 4
chat-script
script-name expect-send
Example:
Router(config)# chat-script Dialout ABORT ERROR
ABORT BUSY ““ “AT” OK “ATDT 5555102 T” TIMEOUT 45
CONNECT \c
Router(config)#
Configures a chat script for use in DDR to
give commands for dialing a modem and
for logging in to remote systems. The
defined script is used to place a call over a
modem connected to the PSTN.
Step 5
interface
type
number
Example:
Router(config)# interface Async 1
Router(config-if)#
Creates asynchronous interface and enters
configuration mode for the asynchronous
interface.
Configure the asynchronous interface. For
sample commands that you can use in
asynchronous interface configuration
mode, see the
.
Step 6
exit
Example:
Router(config-if)#
exit
Router(config)#
Exits interface configuration mode and
enters global configuration mode.
Step 7
interface
type number
Example:
Router(config)# interface Dialer 3
Router(config-if)#
Creates dialer interface and enters
configuration mode for the dialer
interface.
Step 8
dialer watch-group
group-number
Example:
Router(config-if)#
dialer watch-group 1
Router(config-if)#
Specifies the group number for the dialer
watch list.
Step 9
exit
Example:
Router(config-if)# exit
Router(config)#
Exits interface configuration mode and
enters global configuration mode.
Step 10
ip nat inside source
{
list
access-list-number
}
{
interface
type number |
pool
name
} [
overload
]
Example:
Router(config)# ip nat inside source list 101
interface Dialer 3 overload
Enables dynamic translation of addresses
on the inside interface.
Command
Purpose
