Cisco 1801, Configuration Manual

Page: 89 / 198

7-3
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
OL-6426-02
Chapter 7 Configuring VPNs Using an IPSec Tunnel and Generic Routing Encapsulation
Configure a VPN
Configure a VPN
Perform the following tasks to configure a VPN over an IPSec tunnel:
•
Configure the IKE Policy
• Configure Group Policy Information
•
Enable Policy Lookup
• Configure IPSec Transforms and Protocols
•
Configure the IPSec Crypto Method and Parameters
• Apply the Crypto Map to the Physical Interface
Configure the IKE Policy
Perform these steps to configure the Internet Key Exchange (IKE) policy, beginning in global
configuration mode:
Command or Action Purpose
Step 1 crypto isakmp policy priority
Example:
Router(config)#
crypto isakmp policy 1
Router(config-isakmp)#
Creates an IKE policy that is used during IKE
negotiation. The priority is a number from 1 to
10000, with 1 being the highest.
Also enters Internet Security Association Key and
Management Protocol (ISAKMP) policy
configuration mode.
Step 2
encryption { des | 3des | aes | aes 192 | aes 256 }
Example:
Router(config-isakmp)# encryption 3des
Router(config-isakmp)#
Specifies the encryption algorithm used in the IKE
policy.
The example uses 168-bit Data Encryption
Standard (DES).
Step 3
hash { md5 | sha }
Example:
Router(config-isakmp)# hash md5
Router(config-isakmp)#
Specifies the hash algorithm used in the IKE
policy.
The example specifies the Message Digest 5
(MD5) algorithm. The default is Secure Hash
standard (SHA-1).
Step 4
authentication { rsa-sig | rsa-encr | pre-share }
Example:
Router(config-isakmp)# authentication
pre-share
Router(config-isakmp)#
Specifies the authentication method used in the
IKE policy.
The example uses a pre-shared key.