3-46
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
Chapter 3 Installing the 1552 Series Access Points in Hazardous Locations
Mounting on a Wall or a Pole
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Caution
To provide inline PoE, you must use the power injector (AIR- PWRINJ1500-2=) specified for the access
point. Other power injectors, PoE switches, and 802.3af power sources do not provide adequate power,
which might cause the access point to malfunction and cause over-current conditions at the power
source. You must ensure that the switch port connected to the access point has PoE turned off.
Caution
The power injector is not intended to be installed in a hazardous locations environment. If a PoE injector
is required, it must be located in a non-hazardous locations environment.
Refer to these sections for installation details:
•
Access Point Mounting Orientation, page 3-46
•
Mounting the Access Point on a Wall, page 3-46
•
Mounting the Access Point on a Pole, page 3-51
Access Point Mounting Orientation
When mounting an access point on a horizontal or vertical surface, you must ensure that the access point
is oriented with the LED indicators pointing down (see
Chapter 2, “Pole Mount Installation”
positioning allows the LEDs to be visible to someone on the ground below the access point.
You must also ensure the access point is mounted with the hinged access cover facing out.
Note
Omnidirectional antennas are vertically polarized and should be mounted vertically.
Mounting the Access Point on a Wall
The optional pole mount kit contains a mounting bracket for wall mounting. You can use the mounting
bracket as a template to mark the positions of the mounting holes for your installation. You then install
the mounting plate, and attach the access point when you are ready.
lists the material that you
will need to provide in addition to the pole mount kit.