2-30
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
Chapter 2 Before You Begin
Unpacking the Access Point
Unpacking the Access Point
When you are unpacking the access point, do not remove the foam blocks attached to the antenna
connectors. The foam protects the antenna connectors during installation.
To unpack the access point, follow these steps:
Step 1
Open the shipping container and carefully remove the contents.
Step 2
Return all packing materials to the shipping container, and save it.
Step 3
Ensure that all items listed in
“Package Contents” section on page 2-30
are included in the shipment. If
any item is damaged or missing, notify your sales representative.
Package Contents
The typical access point package contains the following items:
•
Access point
•
Cisco product documentation and translated safety warnings
•
Two-pin DC power connector
•
Ground lug (Panduit PLCD6-10A-L) and screws with lock washers
•
Watertight cable glands for Power-over-Ethernet (PoE) ports (depending on the 1552 access point
model, 2 or 3 cable glands are provided)
Note
These cable glands are
NOT
hazardous locations/Ex certified.
Tools and Hardware
The tools and hardware used to install the 1552 access point are described in:
•
Optional Tools and Hardware, page 2-30
•
Optional Tools and Hardware That You Supply, page 2-31
•
Pole Installation Hardware and Tools, page 2-31
Optional Tools and Hardware
The optional tools and hardware that can be obtained from Cisco are:
•
Optional power injector (AIR-PWRINJ1500-2=)
Caution
Caution: Power injector (AIR-PWRINJ1500-2=) is not certified for installation within hazardous
locations environments.
•
Antennas, 2.4/5 GHz (refer to the
“Antenna Configurations” section on page 1-15
)
