Chapter 3 Maintaining the Cisco 10005 ESR
Removing and Replacing Field-Replaceable Units
3-28
Cisco 10005 ESR Hardware Overview and Maintenance Guide
OL-1102-07
Step 12
Reconnect any interface cables to the PRE if necessary.
Step 13
Install the PCMCIA card in the PRE if necessary (see the
“Removing and
Installing a PCMCIA Flash Memory Card” section on page 3-28
). Be sure to
secure the PCMCIA slot cover.
Caution
If you do not screw down the cover of the PCMCIA slot on the PRE, the open
cover exposes the unit to the risk of a harmful ESD event, and might cause
electromagnetic interference (EMI) above the prescribed levels.
Step 14
Refer to the
Cisco 10000 Series ESR Software Configuration Guide
for
information about configuring the PRE if necessary.
Note
It is not necessary to configure the PRE if this is a second PRE installation
for redundancy. The system automatically downloads the necessary
configuration information from the primary PRE.
Removing and Installing a PCMCIA Flash Memory Card
To remove and install a PCMCIA flash memory card:
Note
For information about formatting flash memory cards and disks, see the
“Formatting Flash Memory Cards and Disks” section on page 3-4
.
Step 1
Attach an antistatic wrist strap to your wrist and to the ESD socket on the chassis,
or to a bare metal surface on the chassis or frame.
Step 2
Loosen the captive screw on the PCMCIA flash card cover on the PRE
(
Figure 3-17
).
