Chapter 3 Maintaining the Cisco 10005 ESR
Removing and Replacing Field-Replaceable Units
3-24
Cisco 10005 ESR Hardware Overview and Maintenance Guide
OL-1102-07
Step 9
Simultaneously pivot both ejector levers toward each other (until they are parallel
to the faceplate) to firmly seat the card in the midplane.
The line card cycles through its power-on self-test. The Fail LED stays on briefly
(about 5 to 6 seconds) and then shuts off. If the Fail LED remains on or flashes,
refer to the
Cisco 10000 Series Troubleshooting Guide
.
Step 10
Secure the line card in the chassis by tightening the left and right captive screws.
Caution
To ensure that there is adequate space for additional line cards, always tighten the
captive screws on each newly installed line card
before
you insert any additional
line cards. These screws prevent accidental removal and provide proper grounding
for electromagnetic interference (EMI) shielding.
Step 11
Reconnect any interface cables to the line card if necessary.
Step 12
Configure the line card if necessary. (See the
Cisco 10000 Series ESR Software
Configuration Guide
for information about configuring the line card.)
Note
It is not necessary to configure the line card if this is a replacement
installation. The system automatically downloads the necessary
configuration information from the PRE.
